| Required Additional Configuration Parameters | PocketPORT Firmware v1.4 and later:
NONE
PocketPORT Firmware v1.3:
UMW190VW: NONE
UMW190NCD:
DefaultVendor=0x106c DefaultProduct=0x3b05 TargetVendor=0x106c TargetProduct=0x3716 CheckSuccess=20 MessageContent=555342431234567824000000800008ff024445564348470000000000000000
If not "NONE", add the text in red above to the Additional Configuration Settings field or add a blank space (not a newline) and the string above to end of the
Generated Settings field and then
Write the full configuration to persistent memory.
For firmware versions prior to v1.6.7, any required additional configuration parameters must be re-entered every time the PocketPORT configuration is saved.
|
| Comments | Please check the part number on the back of the UMW190 and refer to the Required Configuration settings above. Configure the PocketPORT before inserting the USB mode. After writing the configuration parameters to persistent memory, power off the PocketPORT, inserrt the USB modem and power the PocketPORT back on. Signal strength will not display until the DevicePort has been set to ttyACM0 and the configuration has been saved and the PocketPORT is restarted. |
